8 Port Power over the NET™

The PN0108 Power Over the NET™ is a control unit that offers remote power management for up to eight devices (computers, hubs, routers, etc.). When connected to an ATEN or Altusen TCP/IP accessible module via its PON (RS232) port - see the diagram below - it allows administrators from any computer connected to the internet, whether down the hall, or half way around the world - to control the power off, power on, and reboot status for each attached device.

Features

Remote power on/off/reboot control for eight outlets via TCP/IP and a built in RS-232 PON (Power over the Net) port.
Local power on/off/reboot control via the PN0108's PON port to the computer's RS-232 port.
Daisy chain up to 15 additional stations to control up to 128 outlets.
Manual switching between Local and Remote access for each port via front panel push button switches.
Individual control of each port - users can set the power on sequence and delay time for each port to allow equipment to be turned on in the proper order.
Easy setup and operation via a GUI interface.
Provides three configuration/management methods: Browser; Telnet; or Console Terminal.
Safe shutdown and rebooting for Windows systems*.
Overcurrent protection and recovery for each AC port (110 V model only); total port overcurrent protection (both models) - remote users can monitor the current status via the GUI interface.
Separate circuits for the unit's power and the power to the devices – the power control status menu is still accessible even when an overcurrent condition trips the devices'circuit breaker
On/Off scheduling - allows everything from a one-time start/shutdown, to daily, weekly, etc. starts/shutdowns at user-specified times.
Port grouping - perform the same action on a specified group of ports.
LEDs for easy status monitoring.
Two level (Administrator and User) security.
Configuration can be reset.
Firmware upgradeable - daisy chained stations receive the upgrade via the daisy chain bus.